21 - 30 of 33 Results
Most plastic is discarded after a single use, with about 76 percent of plastic waste discarded into landfills annually. The current practice is wasting feedstock resources, energy, and carbon used for their production.
Adhesives for metal parts typically are liquid-based which require complex processing. This technology is a hot melt adhesive that is mixed and applied in a solid form and after the heating and cooling cycle creates strong bonds with the substrates in a matter of seconds.
The co-processing of cathode and composite electrolyte for solid state polymer batteries has been developed. A traditional uncalendared cathode of e.g.
This technology aims to provide and integrated and oxidation resistant cladding or coating onto carbon-based composites in seconds.
Electric vehicle drive fluids must have a high dielectric constant to avoid current leakage or even short circuits. On the other hand, lubricants should possess sufficient conductivity to allow static electricity to be released.
Efficient CO2 capture using deep eutectic solvents with modular, scalable membrane contactors.
Ionic liquids comprising quaternary ammonium and phosphonium cations have been developed as eco-friendly lubricant additives. These additives are tailored for use in environmentally acceptable lubricants (EALs) like polyalkylene glycols, vegetable oils, and synthetic esters.
Adhesive and sealant materials are crucial in construction, automotive, and electronics industries. However, most adhesives fail under stress or environmental conditions like dust, water, or wear.